Nobody tabs every part, but tabbing by size is useful even on a plate
that has a support grid. Cutting Settings > Tabs now offers "Only tab
parts the support grid can't hold level" or "Tab parts by size"
(CuttingParameters.TabBySize), which ignores the bed and tabs each part
whose minimum-area bounding rectangle's narrow side is in the range.
The support grid choice still falls back to that range on plates with
no bed, as before.
The range fields become TabSizeMinWidth/TabSizeMaxWidth; their JSON
keys stay noBedTabMinWidth/noBedTabMaxWidth so saved settings and nests
read unchanged. TabsEnabled stays as the per-contour flag Plan Cutting,
Place Lead-in and drawing pins set on the parts they tab.
Saved user settings with "Tab every part" read as tabs by size from 0
to 9999, which tabs the same parts. Only the user's settings migrate;
a plate's recorded parameters and pins replay as planned.
Plan Cutting, Place Lead-in and the pre-post review all go through
SupportTabSettings, so they agree on which parts need a tab. A
size-tabbed part is held by any clear tab, so it is never a rapid
obstacle.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Plan Cutting saved its settings only on a successful Apply, so a plate
that would not plan lost them. Each open then laid the machine's leads
back over the last parameters, and the cutting panel rebuilt parameters
from scratch, dropping kerf and the machine/material/thickness stamp.
Save the settings when the dialog is accepted, keep the panel's
unexposed fields, and only apply the machine's leads when the last
parameters were not already taken from that machine, material, grade
and thickness.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
ajandClaude Opus 5.5