F1 opening help kept taking over from placing a part. Help stays on
the Help menu and F1 belongs to the Clone tool alone.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Desktop test classes each kept identical PumpUntil, Show, Mouse, All,
PressKey, Raise, SetBackingField and Field helpers. They now import
FormTesting and TestReflection; the two Field variants that read a base
type's field or unwrap DrawingLibraryForm keep a one-line wrapper.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Limits are plain coordinates, so moving a cut-off left the lines trimmed
to it stopping where it used to be. A drag now takes along perpendicular
lines with a limit or gap edge on its center, extending or trimming them
to keep meeting it.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Trim refused the piece between two crossing cut-offs because a cut-off had
one start and one end, so a line could not be stopped short around a pocket
of parts without deleting it and drawing two. A cut-off now carries Gaps,
stretches between its limits left uncut: segment generation excludes them
like parts, so the line splits into segments that each take their own place
in the cut sequence. Trimming a middle piece adds a gap from one crossing
centre to the other (merged with any it touches), Extend near a gap's edge
closes it, and Swap Through-Cut refuses a junction a gap touches rather
than guess which side of the gap should run through.
Every reader of the limits treats a gap as uncut, so nothing waits for,
warns about or credits a cut that never happens: segment spans stop at a
gap, the cutting dependencies skip a part inside one, the clamp check
ignores a clamp inside one, the cutting-state and overlap stamps go stale
when gaps change, and a gapped line is never full span for the expected
remnant or automatic cut-offs. Gaps persist as an optional gaps array;
older versions ignore it and would cut straight through.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Operators could only drag or delete a cut-off, so changing which line runs
through a junction (e.g. letting a vertical split the sheet to keep a whole
remnant beyond it) meant deleting and re-adding lines. Trim/Extend edits the
existing start/end limits instead, so no file-format or planner change is
needed: trims stop on the crossing line's centre, extends run to the next
crossing or the sheet edge, and Swap Through-Cut (right-click a junction)
does both at once, trimming the through line's far side because only the
origin-side edge is certain. Edits undo as one step and re-place the changed
segments with PlateSequencing.PlaceCutOffs so a new separator is cut last.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
ajandClaude Opus 5.5