ajandClaude Opus 5.5 6771533e03 fix(cutting): leave the tab open on a round perimeter ...

A tabbed outside cut is trimmed short of its entry, but the trim only
handled lines and arcs: a round part's outline is one circle, so it was
cut whole. Plan Cutting counted it as tabbed and called the plan ready,
then the pre-post review found no tab and warned that the part may tip.
Cut a tabbed circle as an arc that stops the tab's chord short of its
entry, travelling the circle's own way.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

2026-11-02 17:20:23 -05:00

..

NoBedSupportTabTests.cs

feat(cutting): tab parts by width when the plate has no support bed

2026-10-25 22:02:31 -04:00

SupportAnalyzerTests.cs

fix(support): center tied support tabs across the part's long side

2026-10-20 23:39:05 -04:00

SupportReviewTests.cs

feat(planning): warn about tipping parts and retire legacy lead-in assignment

2026-10-20 23:54:40 -04:00

SupportSlatsTests.cs

feat(support): add slat support beds alongside the grid

2026-10-24 15:33:12 -04:00

TabHeldSupportTabTests.cs

fix(cutting): leave the tab open on a round perimeter

2026-11-02 17:20:23 -05:00