Show Original drew nothing until Simplify ran, and then showed entities that
had already been through import cleanup. The importers now capture the
entities before any optimization and the overlay draws those from load, while
Simplify keeps starting from the cleaned entities.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Customers and design tools hand over SVGs, and getting them in meant a
trip through another CAD tool. CadImporter now reads them like any other
drawing, and plates, programs and converter entities can be written out.
An SVG's numbers are not drawing units, so import converts to the nest's
units and never guesses: only an absolute width or height counts as a
stated size, since px means 1/96 in to browsers but 1/72 in to
Illustrator. Without one the desktop asks, showing the size each choice
gives, and headless callers must pass the scale or the import fails.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Repo-wide sweep with the pinned CSharpier 1.3.0 tool. Whitespace and
line-wrapping only; OpenNest.Engine.Tests (109) and OpenNest.IO.Tests
pass after reformat, full solution builds 0 errors.
Added .csharpierignore so csproj/config XML keeps its existing layout
(CSharpier's XML wrapping churns attributes with zero benefit).
Formatting is now enforceable: dotnet csharpier check . passes.
Add OpenNest.IO/Bending/BendRepair: opt-in repair of unambiguous paired
ETCH/SCRIBE bend ticks, bounded to <=3.175 mm endpoint movement with
explicit source units. Cut geometry is never modified.
- CadImportOptions.BendRepair configures it; CadImportResult exposes
per-bend BendRepairReports; CadImporter/Dxf wire it into import.
- Console: --repair-bends-mm <limit> --cad-units inches|mm prints
per-bend reports for newly imported DXFs.
- New OpenNest.IO.Tests project (net8.0, synthetic DXFs, 30 tests)
covering bend detection and repair, added to the solution.
- Update README.md and CLAUDE.md for the new pipeline and build/test
instructions.
Extract MText and TextEntity from the CadDocument during DXF import
and render them in the EntityView. Handles text alignment (left/center/
right via InsertPoint vs AlignmentPoint) and replaces AutoCAD control
codes (%%p → ±, %%d → °, %%c → ⌀). MText formatting codes are
stripped before display.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
- Drop CadImportResult.Document: no caller reads it after the
migrations (BendDetectorRegistry runs inside CadImporter.Import
itself, and downstream callers only consume the entity/bend data).
- Drop dead CadConverterForm.GetNextColor() helper: zero callers
since GetDrawings stopped needing it.
- Drop stale 'using OpenNest.Properties;' and unused 'newItems'
local in OnSplitClicked.
- Add Import_WhenNamedDetectorDoesNotExist_ReturnsEmptyBends to
cover the previously untested named-detector branch in
CadImporter.Import.
Co-Authored-By: Claude Opus 4.6 (1M context) <noreply@anthropic.com>
ajandClaude Opus 5.5