Slice 3b task 1 (D8/D9): ClampRail gains RemovalMinutes (D9, default
5 minutes, validated finite >= 0) and Plate gains RemovedClamps (rail
clamp ids taken off this sheet as a last resort) plus the computed
ClampRemovalMinutes. Plate.SetClampRail gains an overload that
attaches a rail with a removed-clamp set; zones become the rail's
resolution for the sheet minus those ids, re-resolved on every
resize/rotate so a removed clamp stays off and reappears removed if a
later resize brings it back onto the sheet. ClampRail.Matches gains an
overload comparing against the reduced resolution.
IO: PlateDto.RemovedClamps and ClampRailDto.RemovalMinutes persist
(missing removalMinutes falls back to the default; missing
removedClamps means none). The writer's empty-plate drop logic no
longer drops a sheet whose only content is a removal state the
defaults can't recreate. The reader re-attaches the nest rail to a
plate only when its saved zones equal the rail's resolution minus its
saved removed ids, so a reduced-clamp sheet keeps following the rail
(and the removal) through later resizes instead of freezing as static
zones.
Engine/desktop wiring (minimal-removal computation, Auto Nest
last-resort removal, cut-time, UI) is Slice 3b tasks 2-3, not yet
done.
Tests: 16 new Core (ClampRailTests) + 5 new IO (ClampRailPersistenceTests)
covering validation, resize/resolve behavior, round-trip, legacy
missing-key defaults, and the empty-plate-with-removal-only retention
case. Mutation check (reverting the RemovedClamps subtraction) turns
3 Core + 2 IO assertions red, confirming real coverage.
Gates: Release OpenNest.Tests 3884 passed/31 skipped, OpenNest.IO.Tests
105 passed, OpenNest.Engine.Tests (Clamp filter) 98 passed; scoped
dotnet format --verify-no-changes clean.
A clamp is an avoidance area, so a clamp that only partly reaches a
sheet (for example centered at 60.5" on a 60" sheet, or near the
origin) now keeps its whole 1.5" x 0.625" footprint instead of being
clipped to the sheet; clamps wholly beyond the sheet are still left
off. Job validation accepts a zone that hangs past the sheet edges and
still rejects one that does not reach the sheet at all. Both packing
lanes already block keep-outs extending past the bin; a hanging-clamp
solve through Rectangles, Irregular and Default keeps every part clear
of the whole inflated footprint.
User decision 2026-10-12, settling the plan's pending D2 question.
Add ClampRail: identical clamps (width along the edge, depth into the
sheet) at X centers measured from the plate origin on the origin-side
edge. It resolves onto any sheet size and quadrant without re-scaling:
clamps wholly beyond the sheet are skipped, one still reaching onto it
is clipped to it, and ids follow rail position (clamp-N) so a physical
clamp keeps its id on every sheet.
A plate can follow a rail (Plate.SetClampRail); its ClampZones are then
derived and re-resolved whenever Size or Quadrant changes, because the
clamps are fixed to the machine. Plates without a rail keep explicit
zones unchanged. Nest.PlateDefaults.ClampRail is the template new plates
follow, and Nest.SetClampRail applies a nest-wide rail to every plate
(an empty rail removes it).
aj