Scales down lead-ins that would place the pierce point too close to the
opposite wall of small holes. Uses quadratic solve to find the maximum
safe distance inside a clearance-reduced radius. Adds Scale() method to
all LeadIn types and applies clamping in both the strategy and the
interactive preview.
Co-Authored-By: Claude Opus 4.6 (1M context) <noreply@anthropic.com>
Three issues caused incorrect rendering after lead-in application:
- Rapid move entities from ToGeometry() were included in ShapeProfile
contour detection, turning traversal paths into cutting moves
- Program created with Mode.Incremental default made the absolute-to-
incremental conversion a no-op, leaving coordinates unconverted
- AddProgramSplit didn't call StartFigure() at rapid moves, causing
GraphicsPath to draw implicit connecting lines between contours
- Part.Rotation returned 0 from the new program instead of the actual
rotation, displacing the sequence label on rotated parts
Co-Authored-By: Claude Opus 4.6 (1M context) <noreply@anthropic.com>
Restructure the cutting parameters dialog with separate Lead-In and
Lead-Out GroupBoxes per tab, exposing editable length/angle/radius
fields for lead-outs (previously hardcoded). Add Tabs section with
enable checkbox and width control. Also fix lead-in/lead-out angle
calculations and convert cutting strategy output to incremental mode.
Co-Authored-By: Claude Opus 4.6 (1M context) <noreply@anthropic.com>
Adds LayerType.Leadout to all LinearMove and ArcMove instances produced
by LineLeadOut and ArcLeadOut Generate() methods.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
Adds LayerType.Leadin to all LinearMove and ArcMove instances produced
by LineLeadIn, ArcLeadIn, LineArcLeadIn, CleanHoleLeadIn, and
LineLineLeadIn Generate() methods, plus tests covering all subclasses.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
The exit point should be the corner farthest from the origin so the
perimeter (cut last) ends near the machine home. The mapping was
backwards — Q1 (origin bottom-left) was returning (0,0) instead of
(w,l).
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Exit point from plate quadrant, nearest-neighbor cutout
sequencing via ShapeProfile + ClosestPointTo, contour type
detection, and normal angle computation.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
