On an enclosed machine a cutout slug that tips once cut free can stand up
above the sheet and catch the enclosure door when the pallet changes. The
head already keeps off cut cutouts, so this is about clearing the door, not
the head.
Cutting Settings > Cutouts > "Slice slugs the support grid can't hold
level" (CuttingParameters.SliceTippingSlugs, off by default, saved per
machine thickness and written only when on) makes Plan Cutting cut each
such slug along the bed's contact lines (grid rows and columns, slat center
lines) before the cutout, so no piece keeps a contact and the pieces drop
between the supports. Each slice stops a kerf short of the cutout, so the
pieces stay attached until the cutout's own kerf frees them together. A
slug the bed holds level, or one on no contact, is left whole; a cutout
holding another part or another of its part's cuts is never sliced.
Slices are break cuts emitted right after the drawing's own break cuts,
pierced on themselves and led straight back to their start. The
released-contour proof now leaves out straight break cuts lying wholly
inside one of the part's closed holes, since the grid cells they free are
scrap; break cuts in material still take part. The plan fingerprint only
changes when the setting is on.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The repo mixed variants such as center/centre and color/colour, so a
name could be spelled either way and searches missed half the hits.
Standardize on the US spelling, matching .NET's own APIs (Color, Center).
Wire values owned by other systems keep their spelling: the material
ledger's "Cancelled" hold status and GitHub's "cancelled" job status.
No behavior change beyond the spelling of a few status messages.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Plan Cutting is now the only automatic lead-in assignment, and parts the
support grid cannot hold level are reported wherever they lack a
steadying tab.
- Remove Assign Lead-ins (plate and nest), LeadInAssigner, the lead-in
tool's Auto-Assign button and the Auto Tab size range; old settings
with autoTab sizes still load
- Manual Place Lead-in tabs the clicked entry when support tabs are on
and the grid cannot hold the part (SupportTabSettings)
- New PartSupport finding: Plan Cutting replay and best-effort plans
warn when a drawing pin, a lead-in that does not fit or no single tab
leaves a part unsteady; the pre-post review checks each placed
program's outside tab gap. These warnings replace the advisory
weak-tab notes; only the inside-corner tab note stays advisory, and
never for a pin
- Pinned perimeters keep their pin but carry the support analysis
- Draw grid points as pixel-snapped squares without anti-aliasing
- Post fixtures build lead-ins through a test-only TestLeadIns helper
- Docs: support tabs, pre-post verification and planner notes
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Breakoffs are now picked by their joining line, default to the smaller side as scrap
(flippable), and cut that line between tabs on a new Break layer instead of slots.
Plan Cutting and Assign Lead-ins enter each cut from the scrap with the nest's internal
lead-in, or pierce on the line without one; checks treat break cuts as intentional open
cuts that are not material.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Forming backgauge tabs drawn as open cuts came off the sheet loose and could not be
planned. A breakoff merges the scrap into the outline and cuts the shared edge as
closed slots between tabs, so it stays attached and every pierce lands in scrap.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
ajandClaude Opus 5.5