The Layout label counted parts off the plate or inside the edge spacing, but
nothing showed which part or where, so the user had to hunt for it. Each edge
finding now gets a canvas marker like the overlap and spacing ones: a red
crosshair where a part leaves the sheet and an orange ring at the gap to the
edge, in every visible display mode, with hover text that carries the finding's
message. Markers are retained across edits like the other overlay findings
(only a changed part's marker drops), and a sheet size, edge spacing or outline
change clears them. Validate Nest already located these findings through
PostVerificationFinding.Location.
"Near edge" / "inside the edge spacing" read as a spacing rule rather than a
placement problem, so the label, overlay messages, PlateEdgeReview findings
and the Validate Nest category now say the part is outside the work area. Off
the plate keeps its wording. The PostVerificationKind.EdgeSpacing name stays.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Validate Nest and the pre-post review checked overlaps and part-to-part
spacing but never the sheet itself, so a part dragged past the plate edge,
a lead-in piercing off the sheet, or a part inside the edge spacing could
post without a warning. Only Auto Nest's own layout check held parts to
the work area.
PlateEdgeReview adds two finding kinds:
- OffPlate: any cut, lead or scribe motion past the sheet, or clean
material outside an outlined sheet or over one of its obstacles.
- EdgeSpacing: clean material (leads excluded) outside the work area, or
closer than the largest edge spacing to an outline or obstacle - the
bound Auto Nest's layout check applies, with SpacingSlack, so layouts it
accepted stay clear.
Cut-off parts are exempt. Routing-replay test fixtures sit at the sheet
origin with leads hanging off it; their route assertions now ignore the
sheet-bound kinds, and the post-contract fixture moves onto the sheet.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
ajandClaude Opus 5.5