Equal-cost plans break ties by the largest edge offcut, from any of the
four edges. A caller that wants the leftover off one way, such as a
shop that keeps only end drops, or a benchmark scoring the used sheet
height, had no way to say so. On the converted Nestbolt jobs the
extended Irregular search then found plans whose larger offcut is a
strip down the side, which Nestbolt scores as worse: b-blaz1-strip
3.601 -> 3.867, b-shirts-strip 2.674 -> 2.995.
NestJobOptions.OffcutCut (a CutOffAxis, default null) counts only the
strips one cut along that axis frees, for salvage credit and the
compactness tie-break alike: Horizontal the full-width bottom and top
strips, Vertical the full-length sides. PlateRemnant.LargestOffcut takes
the axis; NestJobCost, the time limit and clamp-removal recovery pass
it on. Unset, nothing changes.
Benchmark manifests accept "offcutCut": "horizontal" or "vertical".
With horizontal, one CPU, 20 s limit, Default:
b-blaz1-strip 3.934 -> 3.333
b-shirts-strip 2.995 -> 2.610
m-box-deep 1.918 -> 1.276 (Nestbolt 1.251)
Manifests accept only the words horizontal or vertical (any case); a
list such as "horizontal,vertical" is rejected. PlateRemnant rejects an
undefined axis. Fixed strategies keep their own no-salvage tie-break
and ignore the option; desktop, Console and MCP do not offer it yet.
Mutation reds: 14/14 (offcut-mutations.py).
Trim refused the piece between two crossing cut-offs because a cut-off had
one start and one end, so a line could not be stopped short around a pocket
of parts without deleting it and drawing two. A cut-off now carries Gaps,
stretches between its limits left uncut: segment generation excludes them
like parts, so the line splits into segments that each take their own place
in the cut sequence. Trimming a middle piece adds a gap from one crossing
centre to the other (merged with any it touches), Extend near a gap's edge
closes it, and Swap Through-Cut refuses a junction a gap touches rather
than guess which side of the gap should run through.
Every reader of the limits treats a gap as uncut, so nothing waits for,
warns about or credits a cut that never happens: segment spans stop at a
gap, the cutting dependencies skip a part inside one, the clamp check
ignores a clamp inside one, the cutting-state and overlap stamps go stale
when gaps change, and a gapped line is never full span for the expected
remnant or automatic cut-offs. Gaps persist as an optional gaps array;
older versions ignore it and would cut straight through.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
A SheetOutline is a closed polygon in plate coordinates with optional
obstacle polygons, normalized to start at the origin; the plate's Size
stays its bounding box. Plate.Area is the material area, rotations turn
the outline, AutoSize and Snap to Standard Size leave it, manual cut-offs
are trimmed to the material the line crosses, the automatic planner
refuses it and no expected remnant is reported.
Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>
Core PlateRemnant.Expected picks a full-span cut-off drop clear of the
parts (less kerf, nominal position for head-locked overcuts), else the
largest salvage edge offcut, else none below the nest's new persisted
MinimumRemnantDimension. NestJobCost's salvage offcut now calls the Core
rule unchanged. NestWriter writes a derived plate expectedRemnant that
readers skip, and /sheets reports it per plate.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
aj
