The Layout label counted parts off the plate or inside the edge spacing, but
nothing showed which part or where, so the user had to hunt for it. Each edge
finding now gets a canvas marker like the overlap and spacing ones: a red
crosshair where a part leaves the sheet and an orange ring at the gap to the
edge, in every visible display mode, with hover text that carries the finding's
message. Markers are retained across edits like the other overlay findings
(only a changed part's marker drops), and a sheet size, edge spacing or outline
change clears them. Validate Nest already located these findings through
PostVerificationFinding.Location.
"Near edge" / "inside the edge spacing" read as a spacing rule rather than a
placement problem, so the label, overlay messages, PlateEdgeReview findings
and the Validate Nest category now say the part is outside the work area. Off
the plate keeps its wording. The PostVerificationKind.EdgeSpacing name stays.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The overlap check now runs the pre-post part spacing scan on its snapshot,
so the canvas label and posting agree. Too-close pairs are counted in the
label and marked with an orange ring showing the gap, with hover details.
A fully checked plate with no findings draws a green check instead of
text; the status bar keeps the wording. Changing the plate's part spacing
now stales the report, and repeated parts share one offset outline so
automatic rechecks stay fast.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The overlap crosshair sat on the pair's area centroid. For a split,
holed or concave overlap, that point can be off the red material:
between two patches, in a hole, or inside a curve.
PlateOverlapPair.Marker is a point inside the pair's largest island.
It is the island's pole of inaccessibility (PolyLabel), searched to a
tenth of the island's area/perimeter within a 4096-cell budget. If
that bounded search does not land inside (a long thin sliver), the
marker falls back to the midpoint of the widest interior run of a
horizontal scan line placed between vertex heights.
The overlay crosshair, marker hit testing, hover coordinates
("Marker:") and the cutting-inspection ring now use the marker.
Centroid stays the true area centroid. View > Overlap Check > Display
> Centroids is now labelled Markers.
Before the marker existed, its call sites used the centroid. Two
patches, a covered frame, a half annulus and a thin crescent then put
it off the material; now all four land on it. Disabling the scan-line
fallback fails its test. On the 389-plate corpus, markers add about
0.4 ms per overlapping pair; pair and area results are unchanged.
ajandClaude Opus 5.5