5776fa80 dropped a tabbed outside's lead-out when it would reach the lead-in,
which silently changed the user's cutting settings. The emitter now keeps the
lead-out as configured again. Plan Cutting plans strictly first, as before;
only when that is refused because such a lead-out may cut its tab free does it
plan again keeping the lead-outs. Each affected part gets a "Tab lead-out"
issue (new PostVerificationKind.TabLeadOut), is treated as cut free for later
rapids, and the plan is UNVERIFIED, so applying it needs explicit acceptance.
The short reorder pass never settles for such a plan, so a clean route still
wins. Locked, fixed and posted programs keep the incomplete-check finding.
The "no single tab can steady it" support warnings caused more trouble than
they solved, so a tabbed part now counts as steady wherever its tab is: Plan
Cutting and the pre-post review warn only about a part cut with no tab at
all, and a tabbed part stays crossable once cut instead of being avoided as
one that may tip. Entry choice still prefers the steadiest tab point.
The problem-nest corpus is unchanged except N26-2AM, whose baseline is now
BestEffort with 15 tab lead-out warnings.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
A tabbed outside cut is trimmed short of its entry, but the trim only
handled lines and arcs: a round part's outline is one circle, so it was
cut whole. Plan Cutting counted it as tabbed and called the plan ready,
then the pre-post review found no tab and warned that the part may tip.
Cut a tabbed circle as an arc that stops the tab's chord short of its
entry, travelling the circle's own way.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Small parts on a coarse support grid (the help tutorial's 5 x 5 gussets
on a 2 inch grid) rest on one or two points, so no single tab could
steady them and every plan came back unverified. New cutting settings
now start "Tab alone holds parts up to" at 6; settings saved without the
field still read as 0, so existing settings keep their meaning.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Small parts such as 1.5" test squares on a 2" laser grid rest on at most
one grid point, so no single support tab can bring their center of
gravity inside the contacts and Plan Cutting warned "no single tab can
steady it" on every one. In practice a part that short stays in the
sheet on its tab, so the bed's contacts don't matter.
Cutting Settings > Tabs gets "Tab alone holds parts up to N long"
(CuttingParameters.TabHeldMaxLength, 0 = off, the default). On a plate
with a bed, a part the bed can't hold level whose length (long side of
its minimum-area bounding rectangle) is within the limit is still
tabbed, but any tab clear of inside corners steadies it, so Plan
Cutting, hand-placed lead-ins and the pre-post review warn only when it
has no tab at all. The setting persists with the cutting parameters and
is part of the plan state fingerprint.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>