The Layout label counted parts off the plate or inside the edge spacing, but
nothing showed which part or where, so the user had to hunt for it. Each edge
finding now gets a canvas marker like the overlap and spacing ones: a red
crosshair where a part leaves the sheet and an orange ring at the gap to the
edge, in every visible display mode, with hover text that carries the finding's
message. Markers are retained across edits like the other overlay findings
(only a changed part's marker drops), and a sheet size, edge spacing or outline
change clears them. Validate Nest already located these findings through
PostVerificationFinding.Location.
"Near edge" / "inside the edge spacing" read as a spacing rule rather than a
placement problem, so the label, overlay messages, PlateEdgeReview findings
and the Validate Nest category now say the part is outside the work area. Off
the plate keeps its wording. The PostVerificationKind.EdgeSpacing name stays.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The status bar's "Layout: OK" ran its own snapshot check of overlaps and
part spacing, separate from Validate Nest and posting, so a part dragged
off the sheet still read OK.
The plate capture now owns the sheet frame (sheet box, work area,
outline), and the worker runs PlateEdgeReview's material check on it:
"N off plate" and "N near edge" join the label. Snapshots hold no leads,
so leads past the sheet stay a Validate Nest/posting finding. The
geometry stamp now includes edge spacing and outline so changing them
marks the result out of date. Bare-part captures (Plan Cutting) have no
frame and are unchanged.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
An empty canvas corner gave no sign of whether a check was still running,
which matters on large nests. A Layout section beside utilization now
follows the automatic check: checking, OK, or findings in red, with the
full wording in its tooltip. It has its own label so rechecks never
replace the last command's status text.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
A pending or running recheck no longer swaps the green check for status
text. A clear result stays as a gray check, and earlier findings stay as
dimmed text, neither of which claims anything about the edited layout.
Views without automatic rechecks still ask for a manual check.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The overlap check now runs the pre-post part spacing scan on its snapshot,
so the canvas label and posting agree. Too-close pairs are counted in the
label and marked with an orange ring showing the gap, with hover details.
A fully checked plate with no findings draws a green check instead of
text; the status bar keeps the wording. Changing the plate's part spacing
now stales the report, and repeated parts share one offset outline so
automatic rechecks stay fast.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Nest windows now rerun the overlap check once the layout has been
unchanged for 0.5 s, instead of leaving 'Overlaps: not checked'. Edits
show 'Overlaps: check pending...'; drags are caught by the paint-time
pose stamp, collection edits by their events. The check waits while a
mouse button, modal dialog or fill is active, supersedes a running check
when the layout moves again, and does not retry a canceled or failed
layout until it changes. Rechecks use the incremental analyzer, so only
the moved parts' neighbors are recomputed.
Automatic results update only the canvas label (the status bar keeps the
last command's message) and keep Display > Off. Check Active Plate still
runs immediately. InvalidateOverlapCheck now also drops cached material.
ajandClaude Opus 5.5