Thicknesses saved before the auto-fill kept a blank Name / Gauge until someone
edited their value, so their nest reports showed only the decimal. Opening
Machine Configuration now names every blank thickness that matches a standard
gauge or plate fraction and marks the form changed, so closing offers to save
them. Thicknesses matching none stay blank, and once saved a reopen finds
nothing to fill and does not ask again.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Reports now take a thickness's name from the machine config, so a blank
Name / Gauge leaves the report with just the decimal. Machine Configuration
now fills a blank name from the standard steel gauge or plate fraction table
when the thickness value changes, and keeps following the value while the
name is still the old value's standard one; a typed name is never replaced.
A new thickness starts named for its default 0.25 (1/4").
Existing blank names are not filled on open, so viewing a machine never marks
it dirty; editing the value fills them.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Desktop test classes each kept identical PumpUntil, Show, Mouse, All,
PressKey, Raise, SetBackingField and Field helpers. They now import
FormTesting and TestReflection; the two Field variants that read a base
type's field or unwrap DrawingLibraryForm keep a one-line wrapper.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Plate > Set as Default and Nest > Edit's Defaults tab only changed the
open nest, so new nests never picked up the values. Set as Default now
also saves the new-nest defaults, and the Defaults tab gains an opt-in
"Use these defaults for new nests" check.
Machine thicknesses can now set part and edge spacing. A nest takes them
when its material, grade, thickness or machine changes and when a release
creates it; BOM import seeds its groups from them. Spacing edited in the
same dialog stays, and only an untouched trailing sheet follows.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Machine Configuration held one lead-in and lead-out per thickness and
applied it to every contour. Each thickness now has Outside Cuts and
Inside Cuts tabs; inside cuts follow the outside leads until "Same as
outside cuts" is cleared, and configurations without inside leads keep
applying one pair to both.
The lead type lists, per-type fields and preview from Cutting Settings
are now a reusable LeadsEditor control that both dialogs use. The
machine tabs hide what the configuration cannot hold: the arc sweep,
the clean-hole kerf (taken from the thickness) and Line + Line.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
ajandClaude Opus 5.5