Bend lines should run perpendicular to the sheet's grain to avoid
cracking on the outside of the bend. The grain warning had it backwards:
it outlined parts whose bends were not parallel to the grain, so on a
60x120 sheet (grain side to side along X) it flagged the correctly
oriented parts and passed the ones bent with the grain.
It now outlines a part when any of its bends is more than 5 degrees off
perpendicular to the plate's grain, and the check is a tested helper.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Drawing.Bends stay in the DXF's source frame while CadImporter moves the
program so its first pierce sits at the origin (Source.Offset). The plate
renderer added part.Location to raw bend points, so every bend and etch
mark was shifted by its drawing's pierce offset, visible on the drawing
library set preview and on plates alike. Remove Source.Offset before
rotating and placing.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>