Commit Graph
2 Commits
Author SHA1 Message Date
ajandClaude Fable 5.2 b137df8428 fix(review): a round part resting on an outlined sheet's edge is not flagged
On a sheet with a custom outline the plate edge review, Auto Nest's layout
check and the runner's candidate validation tested the part's spacing
outline against the usable area. That outline circumscribes arcs by up to
0.001, more than any of their slacks, so a disc whose true bounds rest on
the work-area edge read as inside the outline's edge spacing (or off the
plate at zero spacing) while the same disc on a rectangular sheet, judged
on its true bounds, was clean.

The outline test now works as the part-spacing check does: the spacing
outline finds the candidates and a failure is confirmed on the part's
native contour (NativeContours.Region: arcs circumscribed at 0.000025 and
clipped to the perimeter's true bounds). Both regions contain the material,
so a part past the usable edge by more than the slack still fails; no slack
changed. The runner now calls the layout check's own outline test
(NestLayoutCheck.InsideOutline): its separately flattened candidate could
accept a pose on a slanted edge that the layout check then rejected.

Pushes on an outlined sheet measured the same circumscribed perimeter so a
part would rest where the review passed, and box pushes stopped 0.0012
short of a wall for it. With the review confirming on native contours they
slide the material's own lines and arcs, so a round part rests on a wall
exactly as on the plate edge, and a box push rests the box on the wall.

Co-Authored-By: Claude Fable 5.2 <noreply@anthropic.com>
2026-11-20 08:49:00 -05:00
ajandClaude Fable 5.2 f5fae5c9e1 fix(plate): pushes stop at an outlined sheet's edge; outline import keeps straight edges exact
A plate with a custom outline was pushed against its bounding box only, so
a part pushed toward a missing corner ran through it to the box edge and
ended off the sheet. Compactor's plate pushes (Push, PushBoundingBox,
SettlePlacement, Settle) now also stop at the walls of the outline: the
part of the work area that is not usable material (a missing corner, an
obstacle, each grown by the largest edge spacing). A mover is measured as
the edge review measures it, by the circumscribed perimeter of its clean
material without leads, so it rests where that review still passes. A box
push stops 0.0012 short of a wall so the geometry push after it starts
clear. A rectangular sheet has no walls and pushes exactly as before.

SheetOutline.FromGeometry eroded the whole imported outline by the chord
tolerance, so a sheet drawn 60 x 27 was stored as 59.998 x 26.998 with a
chamfer at every inside corner. Each arc is now chorded on the side that
takes material away (ClipperBridge.FlattenOneSided) and straight edges are
kept exactly. The plate header, the plate list and Edit Plate's outline
size show the size rounded to four decimals instead of the raw double.

Co-Authored-By: Claude Fable 5.2 <noreply@anthropic.com>
2026-11-20 07:49:11 -05:00