A cut-off's place in Plate.Parts is its cut sequence number, but
RegenerateCutOffs removed every cut-off part and appended it again, so
any part drag, fill or cut-off move sent the cut-offs to the end. The
nest file didn't store the position either, so reopening did the same.
RegenerateCutOffs now puts each cut-off back at its previous index (new
cut-offs go at the end), and CutOffDto.Sequence saves the index. Older
files without it load the cut-offs at the end, as before.
Per-entity offsetting left spikes and inverted loops wherever a feature is
narrower than the spacing (1.nest), and RemoveSelfIntersections only
caught proper crossings. The callers that already flatten to polygons now
take a single Clipper region offset instead:
- PolygonHelper (BestFit) and PartBoundary use the conservative mode, which
keeps their never-under-estimate guarantee. PartBoundary also keeps holes
that appear when a perimeter curls back on itself.
- NestValidator offsets perimeter and cutouts in one region; Clipper drops
collapsed cutouts, so the collapsed-or-flipped heuristic goes away.
- CutOff.IntersectPerimeter offsets through the bridge. The old
OffsetEntity(Left) grew CW perimeters but shrank CCW ones, so with the
plate's perimeter cache a cut-off ran through the part; slots narrower
than twice the clearance now close up instead of leaving a gap.
- GetOffsetPartLines (3 overloads) and the AddOffset* helpers had no
callers and are removed, as is EntityView's never-defined DRAW_OFFSET
block.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Repo-wide sweep with the pinned CSharpier 1.3.0 tool. Whitespace and
line-wrapping only; OpenNest.Engine.Tests (109) and OpenNest.IO.Tests
pass after reformat, full solution builds 0 errors.
Added .csharpierignore so csproj/config XML keeps its existing layout
(CSharpier's XML wrapping churns attributes with zero benefit).
Formatting is now enforceable: dotnet csharpier check . passes.
Move 43 root-level test files into feature-specific subdirectories
mirroring the main codebase structure: Geometry, Fill, BestFit, CutOffs,
CuttingStrategy, Engine, IO. Update namespaces to match folder paths.
Co-Authored-By: Claude Opus 4.6 (1M context) <noreply@anthropic.com>
aj
