Machine Configuration held one lead-in and lead-out per thickness and
applied it to every contour. Each thickness now has Outside Cuts and
Inside Cuts tabs; inside cuts follow the outside leads until "Same as
outside cuts" is cleared, and configurations without inside leads keep
applying one pair to both.
The lead type lists, per-type fields and preview from Cutting Settings
are now a reusable LeadsEditor control that both dialogs use. The
machine tabs hide what the configuration cannot hold: the arc sweep,
the clean-hole kerf (taken from the thickness) and Line + Line.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Plan Cutting saved its settings only on a successful Apply, so a plate
that would not plan lost them. Each open then laid the machine's leads
back over the last parameters, and the cutting panel rebuilt parameters
from scratch, dropping kerf and the machine/material/thickness stamp.
Save the settings when the dialog is accepted, keep the panel's
unexposed fields, and only apply the machine's leads when the last
parameters were not already taken from that machine, material, grade
and thickness.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
PEP stores 3/16 as 0.188, which missed the machine's 0.1875 at the
0.0005 in tolerance; widen it to 0.001 in, still far below gauge steps.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Full circles now take InternalLeadIn/InternalLeadOut like every other
cutout; the ArcCircle lead settings and the cutting panel's Arc / Circle
tab are removed. Circle-specific geometry handling (radius clamp, angle
rounding, pierce zone) is unchanged.
Older nest files and desktop settings still load: their arcCircleLeadIn/
arcCircleLeadOut keys are ignored and no longer written, so re-planned
circles take the internal leads. Saved part programs are untouched.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Machine configurations already held a lead-in, lead-out, kerf and cut-off per
material thickness, but nothing read them: Plan Cutting and Place Lead-in
started from whatever was last applied (often another machine's or another
thickness's leads), and cut-offs used fixed view defaults. Now that nests carry
a machine, those values can be the starting point.
- MachineCuttingDefaults maps a machine's thickness settings for the nest's
material/grade/thickness onto CuttingParameters and CutOffSettings,
converting units. Clean Hole stays on holes; Line + Line is not mapped
because the configuration lacks the second segment.
- Plates without their own parameters start from the last-applied ones with
the machine's leads and kerf laid over them; plates with parameters keep them.
- The plate view's cut-off clearance, overtravel, minimum segment and direction
follow the machine on open, on Nest > Machine and after Nest > Edit.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
ajandClaude Opus 5.5