Curved leads turned with the contour winding, which is backwards on outside
perimeters: arc lead-ins arrived against the cut, and Line + Arc / arc
lead-outs went the long way round on one winding. LeadTurn now gives the
arc's turn direction for emission, the pierce-zone check and the preview,
and the arc geometry mirrors with it.
At convex outside corners, curved lead-ins use the first-cut edge's normal
and arc lead-outs the last-cut edge's, whichever edge was picked.
ArcLeadIn gains SweepAngle (degrees, (0, 180], default 180) in the cutting
panel, settings, nest files and cut pins; older files read as 180.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
PEP stores 3/16 as 0.188, which missed the machine's 0.1875 at the
0.0005 in tolerance; widen it to 0.001 in, still far below gauge steps.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Full circles now take InternalLeadIn/InternalLeadOut like every other
cutout; the ArcCircle lead settings and the cutting panel's Arc / Circle
tab are removed. Circle-specific geometry handling (radius clamp, angle
rounding, pierce zone) is unchanged.
Older nest files and desktop settings still load: their arcCircleLeadIn/
arcCircleLeadOut keys are ignored and no longer written, so re-planned
circles take the internal leads. Saved part programs are untouched.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Machine configurations already held a lead-in, lead-out, kerf and cut-off per
material thickness, but nothing read them: Plan Cutting and Place Lead-in
started from whatever was last applied (often another machine's or another
thickness's leads), and cut-offs used fixed view defaults. Now that nests carry
a machine, those values can be the starting point.
- MachineCuttingDefaults maps a machine's thickness settings for the nest's
material/grade/thickness onto CuttingParameters and CutOffSettings,
converting units. Clean Hole stays on holes; Line + Line is not mapped
because the configuration lacks the second segment.
- Plates without their own parameters start from the last-applied ones with
the machine's leads and kerf laid over them; plates with parameters keep them.
- The plate view's cut-off clearance, overtravel, minimum segment and direction
follow the machine on open, on Nest > Machine and after Nest > Edit.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
ajandClaude Opus 5.5