The overlap crosshair sat on the pair's area centroid. For a split,
holed or concave overlap, that point can be off the red material:
between two patches, in a hole, or inside a curve.
PlateOverlapPair.Marker is a point inside the pair's largest island.
It is the island's pole of inaccessibility (PolyLabel), searched to a
tenth of the island's area/perimeter within a 4096-cell budget. If
that bounded search does not land inside (a long thin sliver), the
marker falls back to the midpoint of the widest interior run of a
horizontal scan line placed between vertex heights.
The overlay crosshair, marker hit testing, hover coordinates
("Marker:") and the cutting-inspection ring now use the marker.
Centroid stays the true area centroid. View > Overlap Check > Display
> Centroids is now labelled Markers.
Before the marker existed, its call sites used the centroid. Two
patches, a covered frame, a half annulus and a thin crescent then put
it off the material; now all four land on it. Disabling the scan-line
fallback fails its test. On the 389-plate corpus, markers add about
0.4 ms per overlapping pair; pair and area results are unchanged.
Pre-post clamp checks looked only at nominal cut-off definitions and
rapids. A definition moved without regenerating its placed program
left a cut through an active clamp that posted with no warning, because
cut-off material is excluded from the overlap check.
Also check each cut-off part's placed cutting motions against the
clamps in the placement frame (lines exactly, arcs by their extent).
Report one warning per cut-off part and clamp, so a current definition
does not produce a duplicate of its nominal finding.
Project Memory: opennest cdbe2629-b562-46ee-9509-2b120a511654
Plate.ClampZones are stored relative to the sheet's lower-left corner,
but cut-off positions, motions and part poses use the signed quadrant
frame. The automatic cutoff planner, manual cut-off contacts, clamp
rapid warnings and whole-plate overlap capture compared the two
directly, so in quadrants 2-4 a cut or rapid through a real rail clamp
was neither avoided nor warned about.
Add ClampZoneFrame.ToPlacement, which maps live zones into the
placement frame exactly like the sheet and engine stock, and use it in
every Slice 5 consumer. It rejects missing or malformed zones (bounds
stay publicly mutable); pre-post verification reports those as an
incomplete clamp check instead of a clear result. Overlap freshness now
treats a size or quadrant change as moving the zones.
Tests use real ClampRail zones in all quadrants; the hand-signed
quadrant fixtures that hid the defect are converted to rails.
Project Memory: opennest 274836d5-fb76-4619-b3cc-0c811e767dd6
aj