Files
OpenNest/docs
ajandClaude Opus 5.5 60f9f1cc56 fix(cutting): enter a holed part's outside on the way to the next cut
Long holed strips on a support grid were entered mid-length, and those
resting on a line of contacts beside their center of gravity on the far
side, so the head left back over the strip. Four causes:

- A support tab that cannot hold a part level still led its entries with
  the steadiest point. No such entry steadies the part enough to be worth
  a detour, so every entry clear of inside corners now ranks toward the
  next cut, as for an untabbed part. The part is still tabbed and still
  avoided once cut.
- A next part level with this one's center faced the bottom by rounding.
  A level target now faces neither side on that axis.
- The tab-retention check measured a lead-in against the start tangent,
  so a straight in-line corner lead-in on a tabbed outside, which runs
  back off the part while the gap lies along the other edge, was refused
  at every corner. A part's only open cut now measures toward its gap.
  Cutouts cut in pieces keep the old rule.
- Travel measured from before the part, not from its cutouts.

A holed part now tries first the outside entry where the straight line
from its cutouts to the next part's leaves it: the shortest way between
them. The search and contour recovery both lead with it; every check
still applies.

The problem-nest corpus ranks no plate below its baseline, and none at
80% of its budget; five ConstraintConflict plates now plan BestEffort.
Five planning fingerprints change, all still Ready: rapid travel drops
14-17% on four and rises 0.5% on mixed-irregular. A kept-order replan
after a cut-off segment may now find a shorter route than the plan, so
that test checks the route is no longer rather than identical.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-21 10:22:04 -05:00
..