mirror of
https://github.com/ajisaacs/OpenNest.git
synced 2026-11-22 04:17:40 -05:00
Long holed strips on a support grid were entered mid-length, and those resting on a line of contacts beside their center of gravity on the far side, so the head left back over the strip. Four causes: - A support tab that cannot hold a part level still led its entries with the steadiest point. No such entry steadies the part enough to be worth a detour, so every entry clear of inside corners now ranks toward the next cut, as for an untabbed part. The part is still tabbed and still avoided once cut. - A next part level with this one's center faced the bottom by rounding. A level target now faces neither side on that axis. - The tab-retention check measured a lead-in against the start tangent, so a straight in-line corner lead-in on a tabbed outside, which runs back off the part while the gap lies along the other edge, was refused at every corner. A part's only open cut now measures toward its gap. Cutouts cut in pieces keep the old rule. - Travel measured from before the part, not from its cutouts. A holed part now tries first the outside entry where the straight line from its cutouts to the next part's leaves it: the shortest way between them. The search and contour recovery both lead with it; every check still applies. The problem-nest corpus ranks no plate below its baseline, and none at 80% of its budget; five ConstraintConflict plates now plan BestEffort. Five planning fingerprints change, all still Ready: rapid travel drops 14-17% on four and rises 0.5% on mixed-irregular. A kept-order replan after a cut-off segment may now find a shorter route than the plan, so that test checks the route is no longer rather than identical. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>