mirror of
https://github.com/ajisaacs/OpenNest.git
synced 2026-11-22 09:57:40 -05:00
test(corpus): guard where an Auto Nest problem nest's last sheet ends
An auto-nest baseline was a sheet count. A job that does not fill its last sheet can get much worse without taking another one: N26-2CJ went from ending at 75.2" to 62.1" on one sheet either way, so the corpus would have passed a layout back at 75.2". The baseline line may now also say where the last sheet ends, "auto-nest: 1 sheets, ends 62.2": how far along the sheet's length its material reaches, measured from the end the layout starts at, the same figure in every quadrant. At the baseline's sheet count a layout ending more than 0.05 past it fails; one ending sooner is reported with the line to record. A line without "ends" checks the sheet count alone, and older code reads the new line as its sheet count. Co-Authored-By: Claude Fable 5.2 <noreply@anthropic.com>
This commit is contained in:
1 parent
b137df8428
commit
97fc5be021
2 files changed
+133
-11
No files matched your search
+11
-1
@@ -68,6 +68,15 @@ fewer sheets are only reported. Run it with `OPENNEST_PROBLEM_NESTS_CHECKS=auto-
|
||||
naming only planner areas skips it, and the planning test skips nests guarding only `auto-nest`
|
||||
and runs not at all for a filter naming only `auto-nest`.
|
||||
|
||||
A job that does not fill its last sheet can get worse without taking another sheet, so the line
|
||||
may also say where that sheet ends: `auto-nest: 1 sheets, ends 62.2`. The end is how far along the
|
||||
sheet's length the last sheet's material reaches, measured from the end of the sheet the layout
|
||||
starts at (the right edge of a layout packed from the left; the same figure in every quadrant).
|
||||
With the baseline's sheet count, a layout ending more than 0.05 past the recorded end fails; one
|
||||
ending sooner is only reported, with the line to record. A line without `ends` checks the sheet
|
||||
count alone. Every run prints each nest's end, and a missing baseline's failure prints the whole
|
||||
line, the end rounded up to a tenth.
|
||||
|
||||
### Fill nests
|
||||
|
||||
`ProblemNests_FillNoWorseThanTheirBaselines` takes the nests whose `checks:` line names `fill`
|
||||
@@ -122,7 +131,8 @@ Plates use their own cutting parameters. A plate without them uses line lead-ins
|
||||
and which commit fixed it, if any.
|
||||
3. Add a baseline line to the comments, with plate numbers counted from the first plate:
|
||||
`planning: 1=NoSolutionWithinBudget 2=BestEffort`. An Auto Nest problem takes
|
||||
`auto-nest: 2 sheets` instead, the sheet count Auto Nest reaches today, and a fill problem
|
||||
`auto-nest: 2 sheets` instead, the sheet count Auto Nest reaches today (`auto-nest: 1 sheets,
|
||||
ends 62.2` when the problem was how far a part-filled last sheet reached), and a fill problem
|
||||
`fill: 1=33`, the part count each listed plate's fill reaches today (`fill (Strip): 1=33` for
|
||||
a strategy other than Lattice). A fill plate must hold one drawing: the fill uses it.
|
||||
To get the line, save without one and run the test: the failure prints the observed line.
|
||||
|
||||
Reference in new issue
Block a user